![]() No center detection available only detects the rough area of stud location.Detects both wood and metal studs for added versatility suitable for thick studs.Straightforward operation suitable for first-time users as well as professionals.Lightweight compared to similar options suitable for transporting to the jobsite.For the cost, you can’t beat the accuracy. A standard 2-by-4 stud is 1½ inches thick, so by measuring 0.75 inches from where the Craftsman indicates the edge of a stud, you’ll find the center. This wall scanner comes with an edge sensor only, but that’s all you need to find a stud. When the sensor detected the edge of a stud, the tool emitted a beep, and the “Edge” light on the front lit up. I ran the Craftsman stud finder over the test wall and then over a standard wall. With this stud finder, I discovered the user has to hold the power button down while scanning-let off the button and the tool goes back to sleep. A beep and a green light on the top lit up to indicate the stud finder was ready to go to work. I put a 9-volt battery in the stud finder and pressed the power button on the side. I didn’t hold out much hope that it would do the job. I was a bit surprised on the first inspection of the Craftsman stud finder it weighs less than 4 ounces, and it’s just 5½ inches long. This basic Craftsman Stud Finder doesn’t come with a lot of bells and whistles, but it gets the job done-and at a very attractive price point. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |